I have to specify a thread in a plastic container with lid, the container will have an o-ring and is intended to hold 1 liter of water. The diameter is approximately 110.00 mm and the pitch should be about 10 mm. I am looking for a standard specification for the thread tooth cross section. Can any one recommend an SPI, SPE, ASME or other standard that will cover plastic threads for an application similar to mine? Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Standard for Thread in Plastic
- Thread starter hbarea
- Start date
ornerynorsk
Industrial
Yes, there are standards in the container and closure industry. I don't have my reference books handy, though. Someone will steer you right on this thread.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question