Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Staadpro Lateral Tosional Buckling Failure for SS6

Status
Not open for further replies.
KeithBabara

KeithBabara

Civil/Environmental
Joined
Sep 28, 2011
Messages
1
Location
SG
I often encounter steel members failure due to LTC of a normalised ratio of 340.3E36,
which is relatively high.
I'm experiencing this phenomenal only in Select Series 6, the versions below 6 do not show this issues.
Can anyone explain the causes of this?
 
 http://files.engineering.com/getfile.aspx?folder=3cca451c-c557-4f47-a909-1efaaf152e70&file=2.4-SP_WITH_90_BEND.std
Status
Not open for further replies.

Similar threads

Facundo L. Pfeffer
  • Locked
  • Question Question
Correct way to perform nonlinear buckling analysis
Replies
6
Views
2K
centondollar
centondollar
zidane.imade
  • Locked
UMAT subroutine for SMA
Replies
3
Views
4K
IceBreakerSours
IceBreakerSours
compe_ad
  • Locked
  • Question Question
Concrete failure point in Abaqus
Replies
4
Views
820
compe_ad
compe_ad
YuJie_PV
  • Question Question
1/2 loading for 1/2 model in ansys?
Replies
9
Views
10K
YuJie_PV
YuJie_PV
WayneKagawa
  • Locked
  • Question Question
Best strategy for verification of tangent for hyperelastic material
Replies
0
Views
683
WayneKagawa
WayneKagawa

Part and Inventory Search

Sponsor

Back
Top