Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SS thicknesses for water storage tanks

Status
Not open for further replies.
solarmike

solarmike

Mechanical
Jan 4, 2004
3
Is there a "rule of thumb" for non asme (under 120gal/450L) tanks holding domestic hot water or boiler water but operating within the excepted temp/pressure limits of our typical systems( ie: 150 lbs relief and 100C)
Thanks
 
Status
Not open for further replies.

Similar threads

enginesrus
  • Locked
  • Question
What brass or bronze for water couplings?
Replies
9
Views
6K
Brooke William
B
metaleng123
  • Locked
  • Question
Knife-line Attack prevention when welding 321 SS 1
Replies
11
Views
742
MFAMET
MFAMET
rollingcloud
  • Locked
  • Question
Procurement spec for 304 ss cold worked bar, ~34 - 39 HRC
Replies
11
Views
790
EdStainless
EdStainless
mthausif123
  • Locked
  • Question
Tube material for DM water 1
Replies
7
Views
442
EdStainless
EdStainless
rollingcloud
  • Locked
  • Question
How much hardness change can I expect from a low-level stress relief on a 17-4 SS part?
Replies
13
Views
830
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom