hello. is it possible to simulate springs in catia?
for example, I'd like to draw 4 round springs that push sheet metal on the top. shet meetal would have limited movment only on horisontal direction. now when I draw shet metal in flat state, is it possible to make it bend automatically in assembly and be left like this or do I have to make a seperate simulation and draw it in bent state? also I'd like round springs to extend automatically.
thanks
for example, I'd like to draw 4 round springs that push sheet metal on the top. shet meetal would have limited movment only on horisontal direction. now when I draw shet metal in flat state, is it possible to make it bend automatically in assembly and be left like this or do I have to make a seperate simulation and draw it in bent state? also I'd like round springs to extend automatically.
thanks
