Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spool Edge Deburring

Status
Not open for further replies.
Replies continue below

Recommended for you

Sort by date Sort by votes
It looks like a lapping tool.
It appears to contact only the OD of the spool, so I'm not clear on how it could specifically remove edge burrs.


Mike Halloran
Pembroke Pines, FL, USA
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

IdanPV
  • Locked
  • Question
Rectangular plate; two edges simply supported, two edge free 4
2
Replies
27
Views
2K
LiftDivergence
LiftDivergence
paulcook
  • Locked
  • Question
Tapped Holes In Aluminum Casting - Distance From Edge 6
2
Replies
35
Views
1K
paulcook
paulcook
cc_aitlin
  • Locked
  • Question
Edge distance using key inserts
Replies
5
Views
648
desertfox
desertfox
Itefaque Rabani
  • Locked
  • Question
Any code or standard reference for not using hammer on pressurized piping spool or line. 3
Replies
7
Views
247
IRstuff
IRstuff
Startto
  • Locked
  • Question
Impact on pressure and flow from spool construction 1
Replies
3
Views
127
hydtools
hydtools

Part and Inventory Search

Sponsor

Back
Top Bottom