Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Split Sleve Couplings 1

Status
Not open for further replies.
ellas1

ellas1

Structural
Dec 20, 2011
28
Any recommnedations on how close before and after Split Sleeve Couplings (Depend-O-Lock Couplings) we should provide supports will be appreciated.

Thank you
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Please refer to the latest edition of AWWA Manual M11 “Steel Water Pipe: A Guide for Design and Installation” for proper support and restraint design considerations.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

abdolmaleki1975
  • Locked
  • Question
SPLIT TEE 3
2
Replies
22
Views
915
SJones
SJones
TugboatEng
  • Locked
  • Question
Compression Couplings
Replies
15
Views
388
TBP
TBP
MartinLe
  • Locked
  • Question
Are there problems with gap corrosion when using pipe couplings (Straub or other suppliers)
Replies
2
Views
156
TugboatEng
TugboatEng
Vindicit
  • Locked
  • Question
Using pneumatic quick disconnect couplings for liquids? 1
Replies
5
Views
1K
Vindicit
Vindicit
Bozo_Sam
  • Locked
  • Question
Multiple Y-fitting to split the flow 1
Replies
17
Views
2K
gsakamoto
gsakamoto

Part and Inventory Search

Sponsor

Back
Top Bottom