I have a copy of DIN 5466-1 2000-10 which I am trying to use to rate some splines. There are some undefined parameters (stress concentration factors and size factors etc) used in the calculations. There is a note given for these parameters that I have transalated as "Standard in Preparation". Does anyone know if there is a mroe recent version of this standard that includes details of the parameters? Is there another source I can use to calculate the parameters?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Spline Load Capacity
- Thread starter phtmh2
- Start date
I'm not familiar with the DIN, but I'd be surprised that the stress concentration factors are undefined.
IHS (the company my agency uses for access to Codes & Standards) shows the most recent version of the standard as the 2000-10-01 version you have.
Patricia Lougheed
******
Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of the Eng-Tips Forums.
IHS (the company my agency uses for access to Codes & Standards) shows the most recent version of the standard as the 2000-10-01 version you have.
Patricia Lougheed
******
Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of the Eng-Tips Forums.
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question