Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Spacing between PEM fasteners
- Thread starter BigDaz
- Start date
![[ponder]](/data/assets/smilies/ponder.gif "[ponder] [ponder]")
Big Daz; There is software out there that can help you do this. Check out Use the English version. I think it allows you to switch to metric once you get in
I always used a "rule-of-thumb" of 1.5 - 2.0 times the screw diameter, depending on the material, for wall thickness. In the 2mm steel you should be OK with the 1.5d You should always test out your calculations before putting them into use. You can get more info about the entire joint design and its safety factors at
Good Luck Bill P.
CSFT, Inc.
I always used a "rule-of-thumb" of 1.5 - 2.0 times the screw diameter, depending on the material, for wall thickness. In the 2mm steel you should be OK with the 1.5d You should always test out your calculations before putting them into use. You can get more info about the entire joint design and its safety factors at
Good Luck Bill P.
CSFT, Inc.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question