Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solidworks Routing From-To lists

Thread starter APPENG
Start date Aug 21, 2009

Status: Not open for further replies.

Aug 21, 2009

APPENG

Mechanical

I am trying to create a route that contains a bunch of single wires, and a cable that consists of two wires and a shield. The shield wire only gets connected on one end but runs the whole length of the route. If i try to do this with a From-To list they expect me to fill in what pin number I wish to connect both ends to.. Like I said, i only want it terminated on one side... anyone have any workarounds for this?

Regards,
Jon
jgbena@yahoo.com