S
SuperCAD
Guest
Hello guys!
I need some help on SolidWorks 2D drawing, I need to know if there is some kind of setting that can be used to connect a command to a layer, like: when I put a center line, the layer automatically changes to the specific layer to that command, the same for section view, dimensions, etc. If this setting don't exist, I think it would be a great idea to add it in the software.
Thank you very much, and please, if you didn't understand what I meant, please tell me, and then I can explain it better.
I need some help on SolidWorks 2D drawing, I need to know if there is some kind of setting that can be used to connect a command to a layer, like: when I put a center line, the layer automatically changes to the specific layer to that command, the same for section view, dimensions, etc. If this setting don't exist, I think it would be a great idea to add it in the software.
Thank you very much, and please, if you didn't understand what I meant, please tell me, and then I can explain it better.
