Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Solid Edge
- Thread starter bsmet95
- Start date
PatCouture
Mechanical
CorBlimeyLImey is right to send you to the UGS solid edge forum.
To answer your question: Yes you can there is an option for this in the properties of the move part command. It should be on the far left of the ribbon bar.
Hope it helps.
Patrick
To answer your question: Yes you can there is an option for this in the properties of the move part command. It should be on the far left of the ribbon bar.
Hope it helps.
Patrick
- Status
Similar threads
- Locked
- Question
- Locked
- Question
