cubalibre000
Mechanical
I'm testing NX9 before to switch all compartments to NX9 and I'm look to the new smart lightweight views.
A part to use with big assembly drawings, can the idea to use this setting very often for single parts or little assembly wrong ?
Which limitations are to use this setting to improve performance drawing in general ?
If the idea isn't wrong, how can resolve situation like the PDF attached ?
Thank you...
Using NX 8 and TC9.1
A part to use with big assembly drawings, can the idea to use this setting very often for single parts or little assembly wrong ?
Which limitations are to use this setting to improve performance drawing in general ?
If the idea isn't wrong, how can resolve situation like the PDF attached ?
Thank you...
Using NX 8 and TC9.1