Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Small Tapered Interlocks

Thread starter MachineSMMC
Start date May 29, 2007

Status: Not open for further replies.

May 29, 2007

MachineSMMC

Industrial

Good Morning,

Not really SolidWorks related but I thought someone here might be able to point me in the right direction.

I am looking for some small tapered interlocks for mold alignment. The smallest I can find are .500 Diameter by 11/16 long. I would really like some .375 Diameter by 1/2 Long. Anybody know of some one who makes these?

Thanks
Chris Tellers