Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
small galvenaized wire brazing
- Thread starter katz
- Start date
If you don't need a whole lot of strength (based on the wire size, you probably don't!) then soldering would be the most expedient means to connect the wire. It could be done with a low heat torch and is much easier to do properly than brazing.
Consider using a high tin solid solder with appropriate flux for the application.
Consider using a high tin solid solder with appropriate flux for the application.
- Status
Similar threads
- Locked
- Question
