Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SLUG Control Valve

Status
Not open for further replies.

tsenthil

Mechanical
Mar 13, 2003
41
What are major factors to be considered for selecting a control valve for Slug application in Oil & Gas Industry?
 
Replies continue below

Recommended for you

The control system that determines that valve position?

Best regards

Morten
 
Slug, are you talking slug catcher level control valves
 
I dont think so - there are quite sucessfull installation where you can reduce are/or remove pipeline slugging (especially terrain induced slugging) by use of measurements and a controll valve.

Other products is a valve on the top of the riser that - while creating a permanent pressuredrop - also will increase the time that a liquid slug will need to "get into the separator" and thus the separator level control system will have time to react.

However Shell has had some sucess in two valve anti slug control - take a look at this presentation:


Best regards

Morten
 
dear MortenA,
if you found solution for your problem i hope to share it with me because i'm intersted by ( remove pipeline slugging )
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor