Slow Environments - PV 360

[SBaugh]

Has anyone seen the environments take about a minute to come up when using PV 360 2010 SP3?

Mine has to keep searching for the Environments, I didn't find anything at the Knowledge base.

Thanks,

Scott Baugh, CSWP

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376

 

[MadMango]

Environments are a tad laggy here, PV360 SP2, but not more than 5 seconds.

Does PV360 SP3 get installed with SW SP4?

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[Eltron]

They pop up in a few seconds here. When was the last time you cleared out your temp files?

Dan

http://www.eltronresearch.com

Dan's Blog

 

[SBaugh]

Good idea Dan I will try that.

Right now I just keep the Environments up all the time and just drag it low in the screen.

I have seen this before, but the solution then was to reinstall and as you know with an Admin image that can be a bit of a pain.

Mr. Mango - in regards to your question I am not following you... sorry if I am missing it... new job is already keeping me up late at night working, so I am a bit tired today.

Scott Baugh, CSWP
Berry Plastics
Cad Admin\Design Engineer

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376

 

[CorBlimeyLimey]

Takes about 3 seconds for me.

Is this on your home machine with the non-approved graphics card?

 

[MadMango]

...PV 360 2010 SP3...

I am using PV 360 2010 SP2, and was wondering if it got bumped to SP3 if you installed SP4 for SW.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[SBaugh]

SP4 is not installed yet, but the admin image has been updated... we have not made the move yet to SP4... waiting to see if SW comes back with the comment to not install because of "XXX" problem.

Scott Baugh, CSWP
Berry Plastics
Cad Admin\Design Engineer

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376

 

[CorBlimeyLimey]

MM ... SW2010-SP4 takes PV360 to SP4

 

[rockguy]

I've had this happen as well from time to time Scott. Not sure why? It seems to fix itself at some point and then could reappear. I haven't figured a reliable way to reproduce.

Rob Rodriguez CSWP

http://www.axiscadsolutions.com

http://www.robrodriguez.com

http://www.robrodriguezblog.com

Eastern Region SWUGN Representative

http://www.swugn.org

http://www.nvtswug.com

SW 2007 SP 2.0