V
VIMAL_VV
Guest
Hi, friends i am a new one over here..
i am screwd by an issue in pro/program in my project. I
am doing a design automation work in a Linear Motion
slide.
Here I wanto switch over from one part to another part
automatically. Based on load input.
Like if your giving an "input Load" equals or more than
"10", the component "A" must be in the assembly.
If the input is less than 10 Component "B" must be on
the assembly.
I can switch over the part by selecting the component in
assembly>replace>unrelated component.and i can access
this part in family table.
But i am not good in coding of this process.Does anyone
please help me by explaining the command which relate
the family table component in pro/program ??...
i am screwd by an issue in pro/program in my project. I
am doing a design automation work in a Linear Motion
slide.
Here I wanto switch over from one part to another part
automatically. Based on load input.
Like if your giving an "input Load" equals or more than
"10", the component "A" must be in the assembly.
If the input is less than 10 Component "B" must be on
the assembly.
I can switch over the part by selecting the component in
assembly>replace>unrelated component.and i can access
this part in family table.
But i am not good in coding of this process.Does anyone
please help me by explaining the command which relate
the family table component in pro/program ??...
