Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sketcher constraints in Layout

  • Thread starter Thread starter Nanimo
  • Start date Start date
N

Nanimo

Guest
I need to do a very simple 2d drawing so I figured I would use the Layout module. However I have a hard time using it as I cannot constraint any of my sketch. Is there any ways to do that? Am I using the right module for the job?
 

Part and Inventory Search

Sponsor

Back
Top