Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sketch Plane in Drafting View

Status
Not open for further replies.

Fortyplus

Mechanical
Joined
Oct 10, 2002
Messages
3
Location
GB
I've imported a Sketch from another Drawing into a new Drawing View.
However when I add new curves they get added onto a different plane(?), so I can't Trim/Extend existing lines to the new ones.

Experimenting with a new part, it appears that Drafting View Sketches are created on the Back Clipping Plane(?).
My imported Sketch isn't?

I've also tried adding Basic Curves in Expand with the WCS set to the Plane of the existing Sketch Curves and
then adding them to the Sketch but it still doesn't recognise that they are on the same plane and won't Trim/Extend.

Anybody have any ideas on how to add new curves to the existing Sketch Plane?

Thanks


NX 7.5.0.32
Windows 7 Pro 64Bit SP1
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top