Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sizing the block in nx 10

Status
Not open for further replies.

jimsled

Automotive
Joined
May 13, 2021
Messages
11
Location
US
Hello all,
Is there an easy way to size the block in NX 10? The measurement of all 3 size of block to add in the bill of material.

Thank you in advance.
Jim L
 
A while back I created a journal that would extract the size info and assign it as part attributes that you could use for the parts list.
thread561-323165
Unfortunately, the result is not associative, if/when the model changes, the journal needs to be re-run to update the values.

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top