When I try to run my Simulink model in external mode so I can monitor the dataflow, the real-time workshop gives the following error:
Could not execute target data map file 'pld_c6000_rtw\pld_targ_data_map' or it does not exist.
Stop the target, delete the pld executable, rebuild the code, and try again. Note that execution of external mode requires the build directory to be present.
I have checked the folder and it does not contain this file, and does not seem to be created when I build the project. I am using the Embedded Target for TI C6000 and a C6713 DSK. The model executes fine when compiled to CCS and run. I have read all of TIs literature and have not had any success. If you have any suggestions, please let me know.
Thanks,
Louis S.
Could not execute target data map file 'pld_c6000_rtw\pld_targ_data_map' or it does not exist.
Stop the target, delete the pld executable, rebuild the code, and try again. Note that execution of external mode requires the build directory to be present.
I have checked the folder and it does not contain this file, and does not seem to be created when I build the project. I am using the Embedded Target for TI C6000 and a C6713 DSK. The model executes fine when compiled to CCS and run. I have read all of TIs literature and have not had any success. If you have any suggestions, please let me know.
Thanks,
Louis S.