Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simulation and laws

Status
Not open for further replies.
RogerJames

RogerJames

Automotive
Joined
Aug 30, 2004
Messages
3
Location
US
I'm looking for a way to control a mechanisim in DMU thru a spread sheet. I could also settle for a way of defining a law using a curve. I know you can make a curve in GSD but I can't find a way of pasting it into DMU.

Eventually, I would like to control three or more motions thru this method.

Any and all ideas are welcome and appreciated. Thanks!

Roger James
Erie Engineering
Stamping Dies and Automation
 
Status
Not open for further replies.

Similar threads

N
  • Question Question
Part mass and CG
Replies
4
Views
6K
nicsachal
N
JSVKAN
  • Locked
  • Question Question
Open Drawing sheet and Renumbering
Replies
1
Views
2K
LWolf
LWolf
A
Cutting and bending
Replies
1
Views
1K
MrCATIA
M
A
  • Locked
  • Question Question
Catia V5/V6 Frame and Title Block CreateSpline
Replies
7
Views
4K
weagan22
weagan22
rookiezzz
  • Locked
  • Question Question
Macro is running more and more slowly
Replies
4
Views
2K
rookiezzz
rookiezzz

Part and Inventory Search

Sponsor

Back
Top