Simplorer Help

[fabiorosan]

Hi everyone.

I've modeled a three-fase induction motor in Maxwell 2D 14.0 and I'm trying to import it in Simplorer to simulate some kinds of starts with reduced voltage.

To begin I imported using the command Subcirtuit > Maxwell Component > Add Transient Cosimulation, and chose the Maxwell file with the modeled motor.

Well, the component appears with two Pins that, I think, gives the rotor velocity: Motion_setup_Out and OMEGA;

In the first one I can conect the VM_ROT which is a Angular Velocity Meter, but the program put between them a block called ROTB_ROT1 that I don't know what it is.
But the velocity shows zero with simulation, even connected correctly the three voltage sources to the windings.


The second one, I even found a block that I can connect to it.

I've already looked for tutorial, manual, exemples in Google, but I didn't found anything that could help me

This project is my Final Project for course graduating. If anybody could help me I would be thankful.

I attached the Maxwell 2D (14.0) model and the Simplorer file if necessary.

http://files.engineering.com/getfil...3bc4-4634-a510-781b65fe86dc&file=Motor_1.mxwl

http://files.engineering.com/getfil...7c2-4953-a0c6-c54c36fb2034&file=Project1.asmp

Thanks,

Fábio