Arthur1493
Mechanical
since the update to NX 11 i have been having this issue where my library components wont update in the view and cannot select them.
see picture attached.
see picture attached.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Siemens NX 11 / library components wont update.
- Thread starter Arthur1493
- Start date
- Status
Are the components loading correctly? Is the library location set in the NX 11 options?
www.nxjournaling.com
www.nxjournaling.com
If you look at the assembly and not the drawing, then try select one of these components , does NX "say" Lightweight body ?
- Using the hotkey "Ctrl+i" you start the command "Information- Object" (*) when trying to investigate things like this the "Info-object" "cuts through" all methods making things non-selectable.
If anything can select mysterious objects, it's the info -oibject. pick the object , OK and you should get information on what type of object that is.
(* Somebody at NX development hid the "information -Object" pretty well in the Ribbon Bar . I had to use the command finder to find it...)
NX does not handle facet bodies * in drawing views. If mixed with solid bodies, the facet bodies will appear as if transparent on top of the solids.
* NX12 can handle faceted bodies of the type Convergent on drawings, but only that type.
Regards,
Tomas
- Using the hotkey "Ctrl+i" you start the command "Information- Object" (*) when trying to investigate things like this the "Info-object" "cuts through" all methods making things non-selectable.
If anything can select mysterious objects, it's the info -oibject. pick the object , OK and you should get information on what type of object that is.
(* Somebody at NX development hid the "information -Object" pretty well in the Ribbon Bar . I had to use the command finder to find it...)
NX does not handle facet bodies * in drawing views. If mixed with solid bodies, the facet bodies will appear as if transparent on top of the solids.
* NX12 can handle faceted bodies of the type Convergent on drawings, but only that type.
Regards,
Tomas
- Status
