Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SHEET METAL
- Thread starter james78
- Start date
- Thread starter
- #2
Actually if you took it into a drawing you get the option to make a falt pattern of the SM part. Then it makes a Derived config of the active config.
You can perform the same operation manually as well.
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
faq731-376
You can perform the same operation manually as well.
Regards,
Scott Baugh, CSWP
faq731-376
- Status
Similar threads
- Locked
- Question