Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Shaping End Turns

Status
Not open for further replies.
mbailey

mbailey

Mechanical
Jan 4, 2002
33
Does anyone know of a better method for shaping end turns rather than beating on them with a dead blow hammer? This seems like it can cause damage to the wire but I'm told that's the way it's done.
 
Status
Not open for further replies.

Similar threads

B
  • Question
[Active Front End Rectifier] Leading current issues
Replies
5
Views
7K
iop95
iop95
crshears
  • Locked
  • Question
[Historic] Convert 25 Hz end of Frequency Changer to 60 Hz Synchronous Condenser 4
Replies
15
Views
6K
waross
waross
EngRepair
  • Locked
  • Question
End Winding Insulation
Replies
5
Views
131
dArsonval
dArsonval
thinker
  • Locked
  • Question
VFD front end current
Replies
2
Views
69
mikekilroy
mikekilroy
ed76
  • Locked
  • Question
How to optimize the space in end-winding of a three-phase induction motor
Replies
3
Views
181
theode
theode

Part and Inventory Search

Sponsor

Back
Top Bottom