cast16
Student
- Nov 8, 2020
- 10
Hi all
I need to design an engine conveyor like that in the attached pictures.
I just have some pictures taken from my colleagues.
My problem for the moment is understand which would be the best connection to the shaft of the end hardened boss/sleeve. I know it need to be keyed for the transmission of the movement, but how to prevent the boss sliding out of the shaft? The only way I guessed is to use a grub screw. Is there any better, more adequate system?
Thank you.
I need to design an engine conveyor like that in the attached pictures.
I just have some pictures taken from my colleagues.
My problem for the moment is understand which would be the best connection to the shaft of the end hardened boss/sleeve. I know it need to be keyed for the transmission of the movement, but how to prevent the boss sliding out of the shaft? The only way I guessed is to use a grub screw. Is there any better, more adequate system?
Thank you.


