raslraslov
Structural
Hi all.
I imported a d3plot file into nCode to perform a fatigue analysis.
Do I need to set units in the settings, such as those that were used when calculating in LS-Dyna?
In LS-Dyna I used the units: GPa, mm, ms. But in the encode settings I can't set the milliseconds. Why?
I imported a d3plot file into nCode to perform a fatigue analysis.
Do I need to set units in the settings, such as those that were used when calculating in LS-Dyna?
In LS-Dyna I used the units: GPa, mm, ms. But in the encode settings I can't set the milliseconds. Why?