Service pack 2.1 & SpaceExplorer

[joelewinski]

I installed service pack 2.1 to our SW Office Pro 2008 installation. I am using a 3DConnexion SpaceExplorer 3D controller. Everything was fine until I installed this new service pack. For some reason, the Isometric, Dimetric, Trimetric and Zoom-to-Fit commands no longer work on the SpaceExplorer. There may be others, but these are the only ones I've noticed so far. I've tried mapping the buttons to other commands and they seem to work, so I know the the button(s) themselves are physically functioning. It's like the commands have been re-scripted or something.

Has anyone else witnessed this yet? If so, did you fix it and how?

T.I.A.

Joe L

 

[Brianh]

I have a SpacePilot and haven't noticed any problems, mapped buttons stayed as they were. Did you check for a driver update on the 3Dconnexion site?

Brian