Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sensor installation on 2" High Pressure Piping
- Thread starter 13392017
- Start date
NozzleTwister
Mechanical
13392017,
THAT IS DEFINITLY NOT OK....
If you're talking about drilling a hole in the side of a 2" pipe and tapping it to screw in a threaded pressure sensor for a 10,000 psi system.
You need to use properly installed fittings designed for the pressure rating of your system.
You scare me,
NozzleTwister
Houston, Texas
THAT IS DEFINITLY NOT OK....
If you're talking about drilling a hole in the side of a 2" pipe and tapping it to screw in a threaded pressure sensor for a 10,000 psi system.
You need to use properly installed fittings designed for the pressure rating of your system.
You scare me,
NozzleTwister
Houston, Texas
- Status
Similar threads
- Question
- Question
- Question
