Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section II, Part D, Table 1A, Note G4 interpretation

Status
Not open for further replies.
Trebormech

Trebormech

Mechanical
Jun 13, 2016
14
Regarding note G4 in ASME Section II, Part D, Table 1A, could somebody please tell me what the phrase "are enclosed within a setting" means?

Thank you.

Trebormech

 
Status
Not open for further replies.

Similar threads

Skatemav86
  • Locked
  • Question
Flange bolts preload stress: ASME II Part D vs. PCC-1 1
Replies
4
Views
668
TGS4
TGS4
shiraz883
  • Locked
  • Question
ASME vs EN 13445| EN 12953 | Allowable stress for EN materials in ASME Sec II part D (Metric)
Replies
3
Views
702
XL83NL
XL83NL
jayinwww
  • Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
191
jayinwww
jayinwww
Maritza Ulloa
  • Locked
  • Question
SA-325 NOT PERMITTED FOR ASMEIII ACCORDING ASME II, PART D SUBPART 1, TABLE 3?
Replies
6
Views
453
r6155
r6155
JT0202
  • Locked
  • Question
B31.3 Table 323.3.4-1
Replies
1
Views
2K
SJones
SJones

Part and Inventory Search

Sponsor

Back
Top Bottom