Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Searching for test standards

Status
Not open for further replies.
dennismckellar

dennismckellar

Materials
Sep 30, 2002
2
I know that there is a test D1308. Is there a test D138?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Muhammad Ijaz
  • Locked
  • Question
Hydrostatic test of tubes
Replies
1
Views
736
EdStainless
EdStainless
G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Muza33
  • Locked
  • Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
664
Muza33
Muza33
gwalkerb
  • Locked
  • Question
A420 Gr WPL6 impact test temperature documentation & unit systems 3
Replies
5
Views
1K
gwalkerb
gwalkerb
Muhammad Ijaz
  • Locked
  • Question
Availability of 3mm thick As rolled ASTM A516 70 plate normalized and impact tested
Replies
0
Views
933
Muhammad Ijaz
Muhammad Ijaz

Part and Inventory Search

Sponsor

Back
Top Bottom