xalxanderx
Mechanical
I figured out how to simultaneously rotate the screw while inserting it linearly. However, i would like to know how to accurately set the amount of rotations for a certain pitch while maintaing the correct linear distance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
screw/pitch
- Thread starter xalxanderx
- Start date
- Status
SeanDotson
Mechanical
Create an equation
linear dist = pitch (linear/rev) * revs
and drive the revolution parameter....
I have a tutorial on the subject (Advanced Motion part 1 & 2) on my site.
Sean Dotson, PE
CAD Professionals & Consultants Discussion
linear dist = pitch (linear/rev) * revs
and drive the revolution parameter....
I have a tutorial on the subject (Advanced Motion part 1 & 2) on my site.
Sean Dotson, PE
CAD Professionals & Consultants Discussion
- Status