Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Saving User Defined Symbols from One File to Use in Another NX5

Thread starter CBuck50
Start date Dec 16, 2015

Status: Not open for further replies.

Dec 16, 2015

CBuck50

Mechanical

Hello everyone,

I have a couple user defined symbols that are saved as part of a part file that I am trying to save in a reuse library in order to be used in new files. I am using NX 5. I have been looking through older posts for a couple hours and have not found what I need. If I may have missed one with this information, please let me know.

Thanks