radar79
Computer
- Jun 19, 2015
- 1
Hello,
I try to find similar subject … So I apologize if I duplicate.
So, the question is…
does anyone know if it’s possible to deactivate/disable the saving bar in NX…
Many times when I close active model and make a save (not before).
NX stay with this 50% saving status on the bar …
In fact NX functionality is still OK but this 50% saving status still exist
even after opening new part and perform save … status is not reset.
The only one way to remove it is to restart NX session…
Can you please provide me some solution for it?
Thank you in advance
Cheers
Radar
I try to find similar subject … So I apologize if I duplicate.
So, the question is…
does anyone know if it’s possible to deactivate/disable the saving bar in NX…
Many times when I close active model and make a save (not before).
NX stay with this 50% saving status on the bar …
In fact NX functionality is still OK but this 50% saving status still exist
even after opening new part and perform save … status is not reset.
The only one way to remove it is to restart NX session…
Can you please provide me some solution for it?
Thank you in advance
Cheers
Radar