Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sampling for mechanical testing of Flanges 32"

Status
Not open for further replies.
federella

federella

Mechanical
Joined
May 19, 2005
Messages
12
Location
IT
I have to establish if it is sufficient the sampling for mechanical testing taken from one separate forged test blanks only valid for Blind and Welding neck flanges 32" or are necessary two different test blanks.
Forged ordered according to ASTM A105 and ASTM A350.
In case are necessary two test Blanks where is clearly indicated on ASTM standards?
 
Status
Not open for further replies.

Similar threads

apolq
  • Locked
  • Question Question
DIN vs ANSI (mating flanges)
Replies
1
Views
960
mk3223
mk3223
4T4
  • Locked
  • Question Question
big bore flange dimensions over 60".
Replies
2
Views
885
4T4
4T4
Harry Houdini
  • Locked
  • Question Question
Standards Regarding Counterbore Clearance Holes for Various Screw Types
Replies
0
Views
3K
Harry Houdini
Harry Houdini
Tio Kio
  • Locked
  • Question Question
For NACE conformance /inspection re
Replies
1
Views
787
jmec87
jmec87
Bohimei
  • Locked
  • Question Question
Question about adequacy of a V-notch weir
Replies
0
Views
227
Bohimei
Bohimei

Part and Inventory Search

Sponsor

Back
Top