S
solidworm
Guest
Before Creo 2.0, i could run ProE on 2 different setups of windows on a single PC (7 and
xp) by running ptcsetup.bat and changing the path to license file, because the same
drive appeared with different labels on 7 and xp. then ProE would run Perfectly. (2
windows, 1 ProE setup) but in Creo 2.0 folders there's no longer a ptcsetup.bat and i
cannot change the path to the license file. how can i do the same thing in Creo 2.0?
xp) by running ptcsetup.bat and changing the path to license file, because the same
drive appeared with different labels on 7 and xp. then ProE would run Perfectly. (2
windows, 1 ProE setup) but in Creo 2.0 folders there's no longer a ptcsetup.bat and i
cannot change the path to the license file. how can i do the same thing in Creo 2.0?
