My inside plastic housing has some holes in it and for push buttons. I was thinking of over-molding rubber on top of it and was wondering how well the rubber would seal out water. If I had a leakage path of one inch and held my product in a bucket with a foot of water above do you think the rubber-over-plastic could keep water out for a few days?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Rubber over-mold on plastic - good sealing?
- Thread starter BrianE22
- Start date