Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Roundness of NPT threads???

Status
Not open for further replies.
doohicky

doohicky

Industrial
Apr 7, 2005
16
We seem to be having an issue with the roundness of a run of the mill 2" NPT plug. Is there anything specifically called out for in the standard that controls this?

Thanks for the help.

Mike
 
Status
Not open for further replies.

Similar threads

tigny
  • Question
repair of scratch on sealing surface of proprietary flanged assembly 1
Replies
2
Views
2K
tigny
tigny
jennin77
  • Locked
  • Question
Tapping via cold forming of a pressure vessel female threads
Replies
2
Views
166
DKTim
DKTim
K
  • Question
Calibration of low Pressure - Vacuum Relief valves
Replies
0
Views
838
Kibar Anderson
K
Karik87
  • Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
456
Karik87
Karik87
R
  • Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance

Part and Inventory Search

Sponsor

Back
Top Bottom