Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Roll forming 1" Bronze?

Status
Not open for further replies.
sprintcar

sprintcar

Mechanical
Joined
Oct 16, 2001
Messages
763
Location
US
Anyone have experience in roll forming Bronze (Alum-Bronze type alloy)- section about 1" square - into rings? I know thin brass forms well but haven't tryed thick sections. Also need a source
Thanks!

Keep the wheels on the ground
Bob
showshine@aol.com
 
Status
Not open for further replies.

Similar threads

enginesrus
  • Locked
  • Question Question
What brass or bronze for water couplings?
Replies
9
Views
6K
Brooke William
B
just_some_shmuck
  • Locked
  • Question Question
Steel mill terminology: "weld repair" - Do mills repair defects?
Replies
6
Views
712
Ng2020
Ng2020
David Maijala
  • Locked
  • Question Question
Cold forming AL alloy in W or AQ condition
Replies
4
Views
489
MagBen
MagBen
b_unruhly
  • Locked
  • Question Question
1215 Hot Rolled vs Cold Rolled
Replies
19
Views
1K
mfgenggear
mfgenggear
rideHPD
  • Locked
  • Question Question
1/4, 1/2 Hard 316 Sheet, Availability/Experience?
Replies
8
Views
1K
TugboatEng
TugboatEng

Part and Inventory Search

Sponsor

Back
Top