Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RISA 3D -> SAP 2000

Status
Not open for further replies.
WillisV

WillisV

Structural
Apr 24, 2005
1,352
Is there a way to move a file from RISA 3D to SAP 2000 including loads and load cases? I am looking at exporting a CIS file with the exporter utility and importing that into SAP which can supposedly read CIS step files, but the results thus far are not encouraging (SAP can't fine the nodes in the CIS file etc).
 
Status
Not open for further replies.

Similar threads

JoshPlumSE
  • Question
RISA pronounced like Liza or Visa
Replies
3
Views
4K
JoshPlumSE
JoshPlumSE
BoHboH
  • Locked
  • Question
Risa 3D to Floor; diaphragm and seismic loads
Replies
11
Views
2K
JoshPlumSE
JoshPlumSE
RattlinBog
  • Locked
  • Helpful tip
Risa-3D - Confirmed error with calculation of hp for singly-symmetric beams AISC 360-16 Sect. F4 1
Replies
7
Views
4K
JoshPlumSE
JoshPlumSE
keen_mentee
  • Locked
  • Question
RISA 3D: WLY in LC Generator 1
Replies
2
Views
1K
WesternJeb
WesternJeb
Attention2Details
  • Locked
  • Question
Risa 3d Multispan Jack Beam
Replies
2
Views
1K
JoshPlumSE
JoshPlumSE

Part and Inventory Search

Sponsor

Back
Top Bottom