Rib Stiffeners Specification for End Plates in Non-Seismic apllications.

[X4vier]

Hello,
I'm looking for rib stiffeners specifications for non-seismic application.
Following the Design Guide 4, I suppose these are only for seismic splices.

Is there any other doc that specify dimensions or requirement for non seismic splices with rib stiffeners?

Thanks

 

[JoshPlumSE]

I'd look at the latest AISC design guide on Bolted End Plate connections. Design Guide 39 is supposed to replace / update both of the older design guides (DG4 and DG-16).

I haven't actually read this guide yet, so I can be 100% sure. But, I'm guessing that it's intent is to be clear about what is required for Seismic and what is not.