Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RG 1/2" Thread called out on Drawing

Status
Not open for further replies.
gard2372

gard2372

Mechanical
Joined
Jun 2, 2006
Messages
1
Location
US
I have a drawing which shows the thread of a hole to be RG1/2”. But R is the designation for tapered and G is the designation for parallel or straight. How can the bushing on the drawing be both straight and tapered at the same time? The detail on the left shows the (RG 1/2") however the detail on the right shows only (G) sizes. I'm not sure they are mating parts, but they were listed together for fabrication. I have no other information other than what is called out on the ISO spec. I have attached the references to both the (R) and the (G) for your everyones review, but then again this whole issue has stumped me.

Is it an ISO RG parralel gauge thread?

If so what Tap size do I use?
 
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
CJonGrey
  • Locked
  • Question Question
TIA-222H Guys
Replies
0
Views
576
CJonGrey
CJonGrey
Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
4T4
  • Locked
  • Question Question
big bore flange dimensions over 60".
Replies
2
Views
885
4T4
4T4
EnggK
  • Locked
  • Question Question
Difference between API 541 and NEMA MG-1
Replies
0
Views
1K
EnggK
EnggK

Part and Inventory Search

Sponsor

Back
Top