Revert to ISO from ANSI....

[designmr]

My question, (Strange). When Solidwork 2007 was initially installed (a couple years ago), it was set to ANSI. For some reason, everytime I start a new Part, Assembly or Drawing, Solidworks starts as ISO. I have to go to System Options, change Dimensioning Standard to ANSI (from ISO), and units from MMGS to IPS.

Where do I go to set the DEFAULT of Solidworks to ANSI and IPS units (without using the re-install DVD'?

Thank you in advance.

 

[Updraft]

Set your part, drawing and assy templates the way you want them and use these for any new file.

- - -Updraft