Result of sectioning two parts 1

[cubalibre000]

Hi,
it's normar this result ?
I've the pin sectioned and the nut not.
Why NX give this result ?

Thank you...

Using NX 8 and TC9.1

 

[Toost]

Bwsh:
If you set the Part-attribute SECTION-COMPONENT = NO on your fasteners, they will not be sectioned in any drawings / section views.
You can then override this attribute in any drawing , if you would like a specific fastener to be sectioned.
Either when creating the section view - Sectioned Component / Solid,
or when the view has been created Edit - View - Section in View...

You can also fastener by fastener set the No section in drawing by drawing, but it's smarter to set the attribute as default.

In this case, i assume that Cubalibre had the desire to present the nuts non-sectioned but the pin sectioned.

Regarding the Hidden Line Hatching, See the attached image for an example where it can be used.
Upper View Off, lower view On.

Regards,
Tomas

 

[Bwsh]

Tomas,

Thanks for the tips.

I guess I mis-understood CubalibreOO's thread on this issue. Sorry for the confusion arised.