trongtamxdkt
Structural
- May 19, 2025
- 2
Hello everyone,
I am currently using Adapt Builder 2019 and facing difficulties with the use of the Splitter tool for support lines around slab openings. Although I have drawn the Splitters, the segmentation of the support lines seems incorrect.
I have attached the model file and would greatly appreciate it if anyone could take a look and guide me on how to properly use the Splitter tool. Link: https://drive.google.com/drive/u/1/folders/1PoQ6zOoxNN0miNUmJkvYghof3J-8i3Yr
Thank you very much in advance!
I am currently using Adapt Builder 2019 and facing difficulties with the use of the Splitter tool for support lines around slab openings. Although I have drawn the Splitters, the segmentation of the support lines seems incorrect.
I have attached the model file and would greatly appreciate it if anyone could take a look and guide me on how to properly use the Splitter tool. Link: https://drive.google.com/drive/u/1/folders/1PoQ6zOoxNN0miNUmJkvYghof3J-8i3Yr
Thank you very much in advance!
