request for macro link

[pejaer]

I am using a macro called "propigate custom property" to pull custom properties to a drawing from the part or assembly model. It works good, but is limited to the global properties and does not pull properties from any of the configurations.

Does anyone know of a similar macro that one can first select the configuration, or pulls configuration specific as long as that config is in the drawing?

Thanks
Paul

 

[ArtemTat]

Could you post this macro?

I believe it is posible to modify an existing macro to satisfy your requirements.

Artem Taturevich, CSWP
Software and Design Engineer
AMCBridge LLC

http://www.amcbridge.com

 

[Eltron]

Check 3 Dawn Consulting. Kevin is a properties macro guru.

http://www.3dawn.com/

Dan

http://www.eltronresearch.com

Dan's Blog

 

[CorBlimeyLimey]

Check out the PropertySync macro by EEnd at

http://www.eng-tips.com

http://www.eng-tips.com/viewthread.cfm?qid=138421

http://home.comcast.net/~ewetemp/SolidWorks/PropertySync.swp

 

[Gupta65]

Check the "Custom Properties for Multiple Part Configurations" by Declan McTiernan

https://forum.solidworks.com/message/64390#64390

Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0

 

[CorBlimeyLimey]

pejaer ... are you wanting to populate the drawing documents properties, or properties linked to notes within the drawing?

Either way, there should be something for you in faq559-1429