I have two parts in sliding contact and would like to view the surface where the two parts are in contact for post processing. I have tried to define a cut plane, but there are portions of the part I would like to remove crossing the boundary obscuring my view as sliding progresses. Is there a way to remove a part in CAE for post processing?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Removing Part for Post Processing
- Thread starter JOJOMO
- Start date
- Status
Similar threads
- Question
- Locked
- Question
- Question
