arling115
Mechanical
- Jun 12, 2012
- 1
Hello,
I need to clamp a dial indicator with a 3/8" stem to a pipe containing a piston. The dial indicator will measure the position of the piston. Concentricity is critical to the measurements being taken.
The size of the pipe will vary set up to set up (~.5"-1.5").
If anyone knows of any stock fittings for this application, it would save the time of custom machining one.
Thanks!!
I need to clamp a dial indicator with a 3/8" stem to a pipe containing a piston. The dial indicator will measure the position of the piston. Concentricity is critical to the measurements being taken.
The size of the pipe will vary set up to set up (~.5"-1.5").
If anyone knows of any stock fittings for this application, it would save the time of custom machining one.
Thanks!!
