Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reduce Mass after Stress Analysis

  • Thread starter Thread starter Galaniann
  • Start date Start date
G

Galaniann

Guest
Im working an assembly. I would like to know if there is a way in Solidworks to reduce material after stress study analysis. Like reduce material at low stress areas and add extra material with high stress areas which were calculated by stress analysis.
Thank you
 
You must log in or register to reply here.

Similar threads

K
  • Question Question
Solidworks Assembly - Using Mass Properties of part instance to control dimensions of parts in assembly
Replies
3
Views
3K
jassco
jassco
BiPolarMoment
  • Locked
  • Question Question
Volume Packing Analysis
Replies
4
Views
480
telecomguy
telecomguy
oharag11
  • Locked
  • Question Question
How do I add a generic mass to a Solidworks part?
Replies
5
Views
2K
oharag11
oharag11
Platypusimon
  • Locked
  • Question Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
1K
jassco
jassco
BiPolarMoment
  • Locked
  • Question Question
PDM Check out file after opening?
Replies
11
Views
1K
BiPolarMoment
BiPolarMoment

Part and Inventory Search

Sponsor

Back
Top